76105 600 LG Air Conditioner Parts List

Screw

Sold individually.

Hose clamp (washer hose clamp)

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Washer lid lock with external safety switch (lid lock)

Mounting bracket on this part replaces old style ( You may need to drill off old bracket before mounting new lock).

Tub to pump hose (washer tub-to-pump hose)

The tub-to-pump hose is a flexible drain hose that connects the outer tub to the pump to carry the water from the tub to the drain pump. This hose is black in color, is made of plastic and measures approximately 17” long with a 1 1/2” diameter. If the hose becomes clogged, broken, or cracked, it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power and water supply before you start this repair.

Tension idler pulley (washer idler pulley)

This idler arm assembly comes with the pulley wheel.

Screw (washer screw)

This screw is less than an inch long. It is a metallic screw that is used for many clothes washers. Sold individually.

Lid switch actuator - black (washer lid switch actuator)

This is part of the lid switch actuator mechanism and activates the lid switch, when the lid is closed, to start the wash cycle and when the lid is open, it stops the cycle.

High temperature adhesive (glue)

The high temperature adhesive is used to create a heat resistant bond between felt seals and rubber gaskets on your appliance. This adhesive is made to withstand hot temperatures. This tube contains one ounce of adhesive. Before starting your repair, it is recommended to wear gloves and ensure that your working area is clean and dry.

Hub and seal kit (washer hub and seal kit)

This kit prevents water from leaking around the drive shaft and down to the bottom of the tub.

Fan assembly,axial (fan blade)

The condenser fan blade circulates air over the condenser to help cool the refrigerant before it enters in to the evaporator. The fan blade fits on the motor shaft, is made of plastic and is approximately 14” in diameter. This is a genuine OEM part. Please disconnect the power to the air conditioner before starting your repair.

High temperature lubricant (lubriplate)

Screw

This screw is sold individually.

Z0062a,screw m4x16,blk

Water inlet valve (washer water inlet valve)

This valve has two ports for water to enter. It also comes with a metallic hose clamp.

Spin bearing (bearing)

The upper spin bearing works in conjunction with your washer. This part is located on the bottom of the outer tub where the transmission goes up through the middle of the tub. The spin bearing is used to support the transmission shaft in the drive system and allows the transmission shaft to be able to spin freely during the spin cycle. When the spin bearing goes bad it can cause noises during the spin cycle and will need to be replaced. This part is made of metal and is secured by mounting screws. The screws are not included, bearing only. This is a genuine OEM part. Please disconnect the water and power supply before starting the repair.